I accidentally deleted one of the faces of my lamp so I duplicated one of its opposite faces to fix this, but I am having trouble positioning it inside the lamp.
Also, something went wrong when I was modelling the top dome-like structure of the lamp. I followed the video tutorial and everything was fine until I reached the point where I had to hold down v and snap to grid. I think something was wrong with my pivot even though I centered it, when I switched to perspective view, the dome-like structure was looking wonky so I deleted it. Should I go back and center my pivot again and then try model the dome again?
Also, something went wrong when I was modelling the top dome-like structure of the lamp. I followed the video tutorial and everything was fine until I reached the point where I had to hold down v and snap to grid. I think something was wrong with my pivot even though I centered it, when I switched to perspective view, the dome-like structure was looking wonky so I deleted it. Should I go back and center my pivot again and then try model the dome again?
No comments:
Post a Comment